IPF XT Pump Family

The IPF XT Family of plunger pumps are designed for a wide variety of moderate pressure washing applications. They are constructed with die-cast bodies and feature brass heads. Internal components include special thick solid ceramic plungers for long life and durability. Precision cast cooling fins are anodized for maximum heat dissipation. Over-sized needle bearing on the drive sides and ball bearings on the non-drive side assure proper shaft alignment and maximum life. Valve cages of specially designed Ultra-Form impervious to water absorption provide positive seating and extended life. One-piece connecting rods are either a special alloy aluminum or bronze at higher pressures, over-sized for strength and load disbursement.

Series Features
Manifold: High strength forged brass for long term use.
Bolts: Six 6mm grade 12.9
Plungers: A special thick solid ceramic for long life, strong durability and more resilience.
Crankcase: Precision die-cast, large cooling fins and anodized for maximum heat dissipation. Sight glass, fill and drain plugs.
Bearings: Oversized for maximum life and load disbursement, two ball bearings. Each bearing is held in position on the crankshaft and crankcase by snap rings. This assures positive alignment and centering of the connecting rods and crankshaft in relation to the crankcase, it also eliminates the crankshaft from floating.
Valves, Seats, and Springs: Stainless steel with specially designed Ultra Form material valve cages that are impervious to water absorption and provide long life and positive seating.
Seals and V-Packings: Continuously lubricating for extended life.
Plunger Rods: High strength stainless steel.
Connecting Rods: One piece special alloy aluminum based and bronze (+1800 PSI) oversized for maximum strength, load disbursement, and long life. Heavy pin area construction, for added load strength.


Flows: 0.5 to 4 GPM
Pressure to: 2200
PSI Speeds: 1450, 1750, 3400 rpm
Shaft Styles: Solid Shaft 24mm, Hollow Shaft 5/8" and 3/4"

Special Note: Use AR64516 Oil. First change oil after 50 hours of use, then after every 500 hours. This oil is specially formulated to provide correcct lubrication properties for our pumps. NO other oil is factory approved for these pumps.

Copyright © 2017 IndustrialPartFinder.com. Powered by Zen Cart